JAZRIDER JR-HAG-TX500-036 Align T-Rex 500 Tail Stabiliser - practical replacement  [JR-HAG-TX500-036]

Align T-rex TRex 500 parts - Plastic Horizontal and Vertical Tail Stabilizer (Fin) - Jazrider Brand [JR-HAG-TX500-036]
Price:
USD$7.99USD$13.06
Brand:
JAZRIDER
Model:
JR-HAG-TX500-036
Condition:
Brand New
Available in warehouse
Write a review

Tail Stabiliser Overview for the T-Rex 500

For owners of the Align T-Rex 500 seeking a straightforward parts upgrade, the JAZRIDER JR-HAG-TX500-036 plastic horizontal and vertical stabilisers provide durable, user friendly replacements. The moulded components are intended to maintain correct tail geometry and withstand routine flying stresses.

Installation and Practical Notes

The JAZRIDER JR-HAG-TX500-036 matches Align T-Rex 500 mounting points for a direct swap in most standard airframes. Installation requires only basic tools and offers an immediate improvement in tail steadiness, making it a sensible choice for everyday hobby flying and maintenance cycles.

Is this part a direct replacement for the factory stabiliser?

Yes, the stabiliser is produced to align with the standard Align T-Rex 500 mounting and geometry for a direct replacement.

What material properties should I expect?

The component is made from impact resistant plastic chosen to minimise weight while offering sensible resistance to everyday wear.

Any setup tips after fitting the stabiliser?

After installation, centre and check the stabiliser alignment, then perform a controlled hover to fine tune gyro and tail trim for optimal tracking.