Jazrider JR-HAG-TX500-011 Practical Stabilizer Bar Kit for Align T-Rex 500  [JR-HAG-TX500-011]

Align T-rex TRex 500 parts - Stabilizer Bar - Jazrider Brand [JR-HAG-TX500-011]
Price:
USD$9.29USD$15.10
Brand:
JAZRIDER
Model:
JR-HAG-TX500-011
Condition:
Brand New
Available in warehouse
Write a review

Durable Jazrider JR-HAG-TX500-011 Stabilizer Bar for Routine Flying

This stabilizer bar from Jazrider is intended to give Align T-Rex 500 pilots a reliable improvement in stability without complex changes. The design suits hobbyist setups where predictable handling and low maintenance are priorities.

Compatibility and Practical Use

The unit is made to align with standard T-Rex 500 head components. It reduces minor cyclic oscillation and helps the helicopter hold attitude during normal park and sport flying sessions.

Installation Notes for Hobbyists

Fitting is straightforward: install the bar, check linkage geometry and secure fasteners. Periodic inspections and keeping pivots clean will extend service life and maintain consistent behaviour.

Is this a direct replacement for the stock stabilizer?

Yes. It is designed to replace the stock bar on the Align T-Rex 500 without major modification in most setups.

What maintenance is recommended?

Regularly check linkages, pivots and fasteners. Clean and lubricate pivot points as needed to prevent wear and binding.

Can I pair this with performance head upgrades?

It can be used with many common upgrades but always verify geometry and clearance when mixing aftermarket components.