JAZRIDER JR-HAG-TX450-001T Alloy Flybar Seesaw Hub - practical replacement for Align T-Rex 450 SE V2  [JR-HAG-TX450-001T]

Alloy Flybar Seesaw Hub Set For Align Trex T-rex 450 AE SE V2 Metal parts - Jazrider Brand [JR-HAG-TX450-001T]
Price:
USD$5.69USD$9.29
Brand:
JAZRIDER
Model:
JR-HAG-TX450-001T
Condition:
Brand New
Available in warehouse
Write a review

Practical alloy seesaw for Align T-Rex 450 SE V2

The JAZRIDER Alloy Flybar Seesaw Hub addresses common wear points on the Align T-Rex 450 SE V2 head by using a durable alloy construction. It is intended as a maintenance-friendly upgrade that keeps the flybar geometry stable over many flights.

Reliable, low fuss upgrade

From a hobbyist perspective, this hub gives a robust pivot surface that reduces frequent rework. The alloy resists nicks and deformation so you spend less time correcting tracking and more time flying.

Fitment and service advice

Engineered for direct fit on the Align T-Rex 450 SE V2, installation is typically quick using common hand tools. After fitment, check blade tracking and tighten fasteners to recommended torque, inspecting periodically for wear.

Can I swap this in during a regular service?

Yes. It is suited to routine maintenance intervals and can be swapped during a regular head check. Keep a spare set of fasteners handy when doing the swap.

Any special care to extend service life?

Keep mating surfaces clean and lightly lubricated where metal-to-metal contact occurs. Avoid overtightening bolts and inspect periodically for micro-cracks or corrosion.

Will this reduce vibration drastically?

It helps reduce vibration related to component flex and wear, but overall vibration also depends on blade balance, head bearings and setup. Address those areas alongside this upgrade for best results.