JAZRIDER JR-HAG-TX450-016 Alloy Rotor Head and Tail Holder Kit for Align T-Rex 450 SE V2  [JR-HAG-TX450-016]

Alloy Main Rotor Head Assembly and Alloy Tail Rotor Holder Assembly Set For Align Trex T-rex 450 AE SE V2 Metal parts - Jazrider Brand [JR-HAG-TX450-016]
Price:
USD$48.99
Brand:
JAZRIDER
Model:
JR-HAG-TX450-016
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Practical Alloy Replacement Components for the T-Rex 450 SE V2

The JAZRIDER JR-HAG-TX450-016 provides alloy main rotor head and tail holder assemblies that are manufactured to align with the Align T-Rex 450 SE V2 mounting layout. These parts are intended for hobbyist use where improved durability and consistent control feedback are priorities. The kit replaces stock plastic components with metal alternatives while maintaining original attachment geometry.

Practical Advantages for Everyday RC Use

  • Material: Robust alloy construction to reduce wear and extend service life.
  • Compatibility: Designed to match the Align T-Rex 450 SE V2 mounting points and dimensions.
  • Performance: Increased stiffness that helps maintain control precision under normal flying loads.
  • Installation: Simple direct replacement intended to keep setup time to a minimum.

What checks should I make after fitting the alloy head?

Check rotor tracking and linkages for correct geometry, re-torque all fasteners, and perform a hover test to confirm stable response before full flights.

Is any special tooling required for this swap?

Standard model assembly tools such as hex drivers and screwdrivers are typically sufficient. Use threadlocker on critical fasteners if recommended for your setup.

How do alloy parts affect repair strategy after a hard landing?

Alloy components can bend or crack differently than plastic. Inspect for deformation and replace any damaged parts; having spares on hand reduces downtime.