JAZRIDER JR-HAG-TX450-013T JAZRIDER JR-HAG-TX450-013T Alloy Rotor Head Assembly  [JR-HAG-TX450-013T]

Alloy Metal Main Rotor Head Assembly Set For Align Trex T-rex 450 AE SE V2 parts - Jazrider Brand [JR-HAG-TX450-013T]
Price:
USD$42.74
Brand:
JAZRIDER
Model:
JR-HAG-TX450-013T
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Practical Alloy Rotor Head for Everyday Flying

This JAZRIDER rotor head assembly is produced with the hobbyist in mind, delivering a durable metal alternative to stock plastic parts for the Align T-Rex 450 SE V2. The design focuses on reliable, repeatable performance during routine flying and club sessions.

Durability and Usability

Constructed from quality alloy, the assembly resists common wear points and reduces flex that can accumulate from frequent use. The result is a head that keeps handling consistent and requires less frequent minor adjustments.

Installation Guidance for Hobbyists

Installation follows standard head swap procedures for the Align T-Rex 450 SE V2. Check link geometry and blade tracking after fitment, and perform small setup tweaks to match your existing electronic and servo configuration.

What maintenance should I do after fitting the alloy head?

Inspect bearings, confirm blade tracking and recheck swash centring. Lightly re-torque hardware after the first short test hover.

Are there recommended torque values for the head screws?

Use conservative torque suited to small RC hardware and avoid over-tightening. If in doubt, consult general small-heli hardware torque references for similar head screws.

Can I transfer my current blade grips to this head?

Yes, compatible blade grips and links can be reused. Replace any worn bearings or linkages to maintain optimal performance.