JAZRIDER JR-SCX607-BK 7075 Aluminium Servo Arm - Practical Steering Upgrade  [JR-SCX607-BK]

Axial 1/6 SCX6 Jeep 7075 Aluminum Steering Servo Arm (Black)
Price:
USD$6.90
Brand:
JAZRIDER
Model:
JR-SCX607-BK
Condition:
Brand New
Available in warehouse
Write a review

Practical Steering Upgrade for Axial SCX6

The JAZRIDER 7075 Aluminum Steering Servo Arm JR-SCX607-BK is a no-nonsense replacement for the Axial 1/6 SCX6 Jeep JLU Wrangler 4WD. Its black anodised aluminium body delivers a durable steering interface that improves response without complicating installation.

Durability and Straightforward Fit

Machined from 7075 aluminium, the arm provides better resistance to wear than plastic alternatives while keeping weight low. It is made to align with the Axial SCX6 Jeep JLU Wrangler mounting pattern for a direct swap using standard fasteners.

Everyday Usability and Maintenance

Hobbyists will find the JAZRIDER aluminium arm easy to service and inspect. Regular checks on mounting screws and cleaning after off-road runs keep the part performing reliably over time.

Will this arm need extra setup after fitting?

After fitting, centre the servo and ensure the arm sits square on the spline. Tighten fasteners evenly and verify steering throws before full use.

Is special upkeep required?

Routine checks are all that is needed: keep the mounting area free of grit, recheck screws periodically, and replace the arm if it sustains a hard impact.

Can I reuse my existing linkages?

Yes, existing linkages and hardware that match the original mounting pattern can normally be reused. Confirm that ball studs and lengths maintain correct steering geometry.