Practical JAZRIDER JR-SCX601-RD Red Aluminium Front Knuckles for Axial 1/6 SCX6  [JR-SCX601-RD]

Axial 1/6 SCX6 Jeep Aluminum Front Steering Knuckle Set (Red)
Price:
USD$23.40
Brand:
JAZRIDER
Model:
JR-SCX601-RD
Condition:
Brand New
Available in warehouse
Write a review

Reliable Front Knuckles for Routine RC Use

The JAZRIDER Aluminum Front Steering Knuckle Set in red is a straightforward durability upgrade for the Axial 1/6 SCX6 Jeep JLU Wrangler. These knuckles replace standard plastic parts to reduce wear and give a practical boost to front end strength for daily trail sessions.

Workshop Friendly Construction

Made from aluminium with an anodised red finish, the knuckles offer a balance of toughness and corrosion resistance. Their fitment is designed to align with SCX6 mounting points so installation is direct and simple for hobbyists maintaining a reliable rig.

Maintenance and Use Notes

Aluminium components are more resistant to impact than plastic, but routine inspection of fasteners and bearings will keep the steering system performing well. These knuckles suit drivers who want dependable, low fuss upgrades for regular trail driving.

How do I check knuckle alignment after fitting?

With wheels on the ground, visually check that link angles and steering tie rods sit parallel and that there is no binding through full lock. Make small adjustments to link lengths if needed.

Do these need special grease or protection?

No special grease is required for the knuckles themselves. Keep pivot points and bearings lubricated with appropriate bearing grease to reduce wear.

Can I reuse my existing hardware?

Often yes, but inspect screws and nuts for wear or corrosion and replace with stainless hardware if you want extra longevity, especially in wet or coastal conditions.