JAZRIDER JR-SCX606-RD Red Aluminium Rear Bumper Mount for Axial 1/6 SCX6 Jeep  [JR-SCX606-RD]

Axial 1/6 SCX6 Jeep Aluminum Rear Bumper Mount (Red)
Price:
USD$20.90
Brand:
JAZRIDER
Model:
JR-SCX606-RD
Condition:
Brand New
Available in warehouse
Write a review

Practical rear bumper mount upgrade for Axial SCX6

The JAZRIDER Aluminum Rear Bumper Mount in red provides a straightforward reinforcement for the Axial 1/6 SCX6 Jeep JLU Wrangler 4WD. It is intended as a daily-use improvement to rear structure and appearance without complex modifications.

Material benefits and everyday use

Aluminium gives a good balance of strength and lightness, making it suitable for a bumper mount that encounters repeated knocks during typical trail driving. This part aims to reduce damage to plastic mounting points while keeping added mass to a minimum.

Fitment, tools and practical tips

Fitment is aimed at matching existing SCX6 rear attachment points and uses common hand tools for installation. Check screw torque after initial runs and clean the mount periodically to prevent grit build up that can accelerate wear.

Is this mount a direct replacement for the stock part?

Yes, it is designed to replace the stock rear bumper mount on the Axial 1/6 SCX6 Jeep JLU Wrangler 4WD using the same mounting points.

Which tools give the cleanest installation?

A set of metric hex drivers, a small torque driver and medium strength threadlocker will produce a secure, long lasting fit without rounding screws.

Any mounting checks after fitting?

Run a short test session, then recheck fastener tightness and inspect for any contact with nearby components. Reapply threadlocker if screws show loosening.