Axial 1/6 SCX6 Rear Shock Tower Upgrade (Aluminum) - JR-SCX604-TI by Jazrider  [JR-SCX604-TI]

Axial 1/6 SCX6 Jeep Aluminum Rear Shock Tower Set (Titianum)
Price:
USD$20.90
Brand:
JAZRIDER
Model:
JR-SCX604-TI
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Rear Shock Tower Summary

Made for Axial 1/6 SCX6 Jeep platforms, this aluminum rear shock tower is supplied under model JR-SCX604-TI as an RC-scale upgrade. It replaces the stock tower to offer a firmer mounting base for rear shocks and help keep alignment consistent during crawling and trail driving.

The listing identifies the item as an aluminum rear shock tower set with the marking "Titianum". It is presented as a scale replacement designed to interface with SCX6 rear suspension geometry and is not intended for full-size vehicles.

Installation notes: intended as a direct swap for the factory rear tower. Installation commonly requires basic hand tools to remove the original tower and fit the replacement; confirm screw lengths and thread engagement prior to final torque. Fit to the chassis mounting points for the Axial 1/6 SCX6 series.

Specifications

  • Item: Axial 1/6 SCX6 Jeep Aluminum Rear Shock Tower Set (Titianum)
  • Material: Aluminum, Titianum
  • Model Number: JR-SCX604-TI
  • Compatibility: Axial 1/6 SCX6 Jeep JLU Wrangler 4WD

Select this aluminum rear shock tower set when you want increased rear mounting stability for scale trail use on Axial SCX6 vehicles and double-check fitment and fastener compatibility before final assembly.

How do I confirm this will fit my SCX6?

Confirm your chassis is the Axial 1/6 SCX6 Jeep JLU Wrangler 4WD variant and compare mounting hole locations to ensure compatibility before purchase.

Should I change shock tuning after fitting the tower?

Because mounting rigidity increases, you may need to tweak spring preload or damping to retain the ride characteristics you prefer.

Is any special hardware required?

Check if the kit includes screws; if not, reuse suitable factory fasteners or source correct length screws to avoid interference.

What material details should I note?

The tower is aluminum listed with the descriptor "Titianum"; inspect finish and mounting surfaces for fit and corrosion resistance as part of routine checks.

Any final fitment advice?

Dry-fit the part to the SCX6 mounting points, confirm clearance for shock travel, and recheck screw engagement after the first few runs.