Axial AX10 Deadbolt Precision Front Offset Link Mount - AX10-24013-OR by Jazrider  [AX10-24013-OR]

Axial Racing AX10 Deadbolt Aluminum Front Offset Axle Link Mount
Price:
USD$11.61
Brand:
JAZRIDER
Model:
AX10-24013-OR
Condition:
Brand New
Write a review

Technical Summary

This is a scale front offset axle link mount intended for the Axial AX10 Deadbolt chassis, model AX10-24013-OR. The unit relocates the front link attachment outward relative to the axle centreline to alter steering and suspension behaviour while remaining compatible with common AX10 Deadbolt installations.

Forged from aluminium, the mount offers improved stiffness at the link pickup compared with many stock plastic mounts, which helps maintain link geometry when loaded and during careful low speed crawling. It is offered as an upgrade component for RC rock crawling and off road tuning where repeatable axle characteristics are important.

Installation notes: the mount replaces the original front link mount using the existing fastener positions on the AX10 Deadbolt axle housing. After fitting, inspect link angles and wheel clearance through full travel and modify link lengths or pivot spacing as needed to achieve the preferred roll centre and steering feel. Check fastener torque periodically after initial use.

What should I look for when trial fitting this mount?

During trial fitting, confirm alignment with the axle housing holes and verify that the relocated pickup does not introduce interference through the suspension travel. Make minor link adjustments as necessary.

Will the aluminium construction reduce flex at the link point?

Yes, aluminium increases rigidity at the link attachment compared with common plastics, which helps retain intended geometry under load and during technical manoeuvres.

Any recommended setup procedure after installing this mount?

After installation, run the suspension through full travel, check wheel clearance, and fine tune link lengths or pivot positions to achieve the desired roll centre and steering behaviour. Recheck fastener torque after initial runs.