Axial AX10 Deadbolt Upper Link AX10-24004-OR by Jazrider  [AX10-24004-OR]

Axial Racing AX10 Deadbolt Aluminum Upper Linkage
Price:
USD$18.58
Brand:
JAZRIDER
Model:
AX10-24004-OR
Condition:
Brand New
Write a review

Upper linkage for AX10 Deadbolt

This anodized orange aluminium upper linkage is an RC-scale replacement intended for Axial Racing AX10 Deadbolt platforms and supplied by Jazrider. The component is finished for durability and serves as a direct-fit upper link that secures axle location while integrating with the suspension to retain designed geometry.

As a hobbyist accessory the item is used to swap damaged OEM links or to maintain consistent alignment when tuning. The aluminium construction aims to balance stiffness and weight typical for scale spares and hop-ups.

Installation notes: the linkage fits the stock AX10 Deadbolt mounting points and uses standard linkage hardware; inspect pins and spacers for wear during replacement. Verify axle position and suspension geometry after fitting by performing simple static checks and a short test run.

Specifications

  • Item: Upper linkage
  • Material: Aluminum
  • Model Number: AX10-24004-OR
  • Compatibility: Axial Racing AX10 Deadbolt

Use this anodized orange aluminium upper linkage to restore or maintain axle alignment on AX10 Deadbolt scale builds and keep suspension geometry consistent for setup work.

Can I use this on other Axial models?

The stated compatibility is Axial Racing AX10 Deadbolt. For other models, compare mount points and clearances before fitting to ensure proper fit.

Is special tooling required to fit it?

No specialised tools are normally necessary; basic hex drivers and pliers used for routine maintenance will handle the swap using existing hardware.

What upkeep does the anodised surface need?

Remove abrasive debris after runs and avoid harsh solvents to keep the anodised finish intact and looking good.

Will this directly replace the OEM plastic link?

Yes, it is designed as a direct replacement for the AX10 Deadbolt upper link using the same mounting points; confirm hardware compatibility as part of the installation check.