Practical aluminium upgrade for Axial AX10 - JAZRIDER AX10-24026-GU  [AX10-24026-GU]

Axial Racing AX10 Aluminum 2.2 D6-spoke Bead-lock Wheel (Gunmetal)
Price:
USD$17.42
Brand:
JAZRIDER
Model:
AX10-24026-GU
Condition:
Brand New
Available in warehouse
Write a review

Practical Bead-lock Upgrade from JAZRIDER

The JAZRIDER Axial Racing AX10 Aluminum 2.2 D6-spoke Bead-lock Wheel in gunmetal is a practical, hobbyist-focused upgrade for Axial Racing AX10 platforms. It is intended to deliver reliable service life and easier tyre management compared with standard plastic rims.

Construction and Serviceability

Manufactured from aluminium, these bead-lock wheels resist common wear points and simplify tyre swaps thanks to the bolted bead ring. The 2.2-inch diameter supports typical crawler tyre choices used in everyday RC use.

Compatibility and Maintenance

The D6-spoke profile gives a good balance between mass and stiffness. The gunmetal finish is robust and straightforward to maintain; routine inspection of bead-lock screws and periodic torque checks will keep the wheel performing well.

What mounting hardware is required?

Standard hex drivers are sufficient. Ensure bead-lock screws are torqued evenly and replace any that show thread wear. Keep a small cross point screwdriver set for ring screws if supplied.

How do these wheels change handling on an AX10?

Aluminium wheels add stiffness and resist deformation under load, which can improve tyre contact consistency. Expect slightly different feedback compared to softer plastic rims, but overall control on technical lines improves.

Are corrosion precautions needed?

Aluminium resists rust but fasteners can corrode. Rinse off mud and dry after wet runs, and consider replacing steel screws with stainless alternatives to reduce maintenance time.