Axial Racing SCX-10 Honcho & Dingo Aluminum Steering Linkage - ASCX10-22403-02-BK by Jazrider  [ASCX10-22403-02-BK]

Aluminum steering upgrade for SCX-10

This aluminum steering linkage is intended as a direct replacement or hop-up for Axial Racing SCX-10 Honcho and Dingo scale crawlers. Made from anodized aluminum and finished in black, it focuses on straight-line steering stability and reduced flex compared with typical plastic linkages. The part is sold as an RC-scale accessory and is intended for model use only.

Installation notes: remove the existing plastic linkage, check thread fit on the steering knuckles and servo horn, and transfer any heim joints or rod ends to the new linkage. Center the servo before final adjustment, then set toe and steering trim on your transmitter. After installation, verify full throw clearance at full steering travel to avoid binding against suspension or chassis components.

Tuning role: swapping to an aluminum steering linkage reduces elastic deflection under load, which helps maintain consistent steering geometry when crawling or addressing high-load turns. Use the linkage to fine-tune steering response alongside servo endpoints and drag link geometry rather than as a sole solution for steering issues.