Axial Racing Wraith Aftermarket C Hub Carrier Aluminum - AW-23012-BK by Jazrider  [AW-23012-BK]

Axial Racing Wraith Aluminum C Hub Carrier (Black)
Price:
USD$10.45
Brand:
JAZRIDER
Model:
AW-23012-BK
Condition:
Brand New
Write a review

Aftermarket Aluminum C Hub Carrier for Wraith

This is an RC-scale replacement C hub carrier designed for Axial Racing Wraith chassis, produced by JAZRIDER as model AW-23012-BK. The part is machined from aluminium and serves as a direct swap for the plastic or stock alloy pieces used at the wheel hubs.

Functionally the C hub carrier locates the wheel hub relative to the suspension and steering knuckle, so it affects toe, scrub radius and steering geometry. As a metal replacement it is intended to increase structural rigidity and wear resistance compared with common stock materials, while remaining compatible with standard Wraith hub assemblies.

Installation is straightforward for hobbyists familiar with hub disassembly: remove the wheel, hub, and existing carrier, transfer bearings and pins where applicable, and bolt the JAZRIDER carrier into place using the original hardware. Verify bearing fit and alignment during reassembly and check steering travel to avoid binding.

Tuning role: swapping to this aluminium carrier is a common, low-effort upgrade when adjusting steering precision or replacing a worn part after off-road use. It is suitable for trail and rock crawling setups where predictable steering response and durability are priorities.

Is this designed to be a direct replacement for Wraith hubs?

It is produced for the Wraith hub footprint and intended as a direct replacement; install with the existing hub hardware and check bearing seating during fitment.

What handling changes should I expect?

Expect reduced hub flex and firmer steering inputs, which often translates to sharper feedback when driving on technical terrain.

Any special installation notes?

Carefully transfer bearings and pins, use original fasteners where possible, and inspect the steering range after installation to ensure there is no interference.