Axial SCX10 II Aftermarket Steel Centre Drive Shaft JR-AS213 by Jazrider  [JR-AS213]

Axial SCX10 II Steel Main Center Drive Shaft
Price:
USD$12.90
Brand:
JAZRIDER
Model:
JR-AS213
Condition:
Brand New
Available in shop
Write a review

Product brief

This JR-AS213 steel main centre drive shaft is an RC-scale replacement made for use with the Axial SCX10 II chassis. It is a direct drivetrain component intended to transfer torque between the transmission and axles for slow-speed technical trail driving and scale rock crawling.

Pay attention to fit during installation: confirm spline and yoke engagement and check for binding or endplay through suspension travel. The steel construction alters rotational inertia and wear behavior compared with common stock materials, so plan lubrication and bearing checks when you fit the part.

Use the shaft to correct play or substitute a worn centre drive element, and confirm clearance with suspension links and skid plates while articulating. Regular inspection after demanding runs will help spot wear at mating surfaces and universal joints.

Is JR-AS213 a direct replacement for the SCX10 II centre shaft?

It is intended to match the centre drive interfaces used on Axial SCX10 II models; confirm your chassis uses the same interface before fitting.

Are additional parts normally required to fit this shaft?

Installation typically uses existing driveshaft mating points on the SCX10 II; inspect yokes and fasteners and replace any worn items to ensure a secure fit.

What maintenance does a steel shaft need?

Regularly inspect mating surfaces and universal joints, keep contact areas clean, and verify bearing condition to reduce premature wear of the drivetrain.