AXIAL SCX24 Brass Front Steering Knuckles JR-SCX2401-HD by Jazrider  [JR-SCX2401-HD]

Axial Racing SCX24 Brass Front Steering Knuckle Set
Price:
USD$8.40
Brand:
JAZRIDER
Model:
JR-SCX2401-HD
Condition:
Brand New
Available in shop
Write a review

Brass front steering knuckles for SCX24 chassis

This brass front steering knuckle set is an RC-scale replacement part made for use with the Axial SCX24 chassis. It replaces the stock steering knuckles with a heavier metal option intended to alter front-end dynamics and provide a different steering feel during low-speed technical runs.

Installation is intended for hobbyists familiar with basic model teardown: remove the wheel and hub assembly, detach the stock knuckle, transfer any bearings or wheel hexes as needed, and fit the brass knuckle using the vehicle's existing fasteners. A set of common hex drivers is sufficient, and no extra machining or special tools are required for standard SCX24 setups.

From a tuning perspective, brass knuckles change front axle inertia and can improve steering feedback on slow-speed rock crawling or scale trail sections where added nose weight helps wheel traction and tracking. They also offer a metal replacement option for those aiming to test different weight and handling balances without altering springs or dampers.

Does this fit the Axial SCX24 without modifications?

Yes. The knuckles are designed for the SCX24 platform and should install to stock mounting points on most standard builds.

Will I need different bearings or screws when swapping to brass?

In most installs you can reuse the existing bearings and fasteners; inspect them during transfer and replace any worn items to ensure a snug fit.

What steering behavior changes should I expect after fitting?

The added mass on the front axle tends to produce steadier steering at crawl speeds, improving traction and reducing sudden twitch responses on rough trail sections.