Axial SCX6 Front Steering Knuckle Set Aluminum Red - JR-SCX601-RD by Jazrider  [JR-SCX601-RD]

Axial 1/6 SCX6 Jeep Aluminum Front Steering Knuckle Set (Red)
Price:
USD$23.40
Brand:
JAZRIDER
Model:
JR-SCX601-RD
Condition:
Brand New
Available in shop
Write a review

Aluminum Front Steering Knuckles for Axial SCX6

The JR-SCX601-RD front steering knuckle set is an aluminum replacement suitable for Axial 1/6 SCX6 Jeep scale models. The kit includes red anodized left and right front knuckles as an option for builders seeking metal components.

These parts act as the steering pivot points at the front hubs. Replacing plastic knuckles with aluminum changes stiffness and wear characteristics, which can be used to tune steering feel or extend component life on scale crawlers.

Fitment notes: these knuckles mount into your front steering assembly and are intended to reuse existing fasteners and wheel hub hardware when sizes match; confirm bearing and hub dimensions prior to install. Basic tools and hex drivers are normally all that is required.

Specifications

  • Item: Axial 1/6 SCX6 Jeep Aluminum Front Steering Knuckle Set (Red)
  • Material: Aluminum
  • Model Number: JR-SCX601-RD
  • Compatibility: Axial 1/6 SCX6 Jeep

As a chassis-specific upgrade for Axial SCX6 front steering, this red anodized aluminum knuckle set suits projects focused on steering refinement or a metal finish; always verify fitment with your hubs and bearings before ordering.

How do I check if JR-SCX601-RD fits my front hubs?

Compare your hub spacing and bearing outer diameter against the knuckle bores; if dimensions match, the JR-SCX601-RD set should install with your existing hardware.

Will the anodized finish chip during use?

Anodize is wear-resistant but can scar from hard impacts and abrasive contact; treat it as a cosmetic finish and expect normal surface wear under heavy use.

What should I look for after installing the knuckles?

Verify steering geometry, ensure there is no binding, and re-torque fasteners after a short test run to confirm secure installation.

Do these knuckles require different fasteners?

They are designed to use standard front hub hardware when compatible; replace fasteners only if sizes do not match the knuckle interfaces.