Axial SCX6 Steering Arm Upgrade - JR-SCX607-TI by Jazrider  [JR-SCX607-TI]

Axial 1/6 SCX6 Jeep 7075 Aluminum Steering Servo Arm (Titianum)
Price:
USD$6.90
Brand:
JAZRIDER
Model:
JR-SCX607-TI
Condition:
Brand New
Available in shop
Write a review

Aftermarket steering arm for Axial SCX6

This steering servo arm suits Axial SCX6 1/6 Jeep models and is sold under the JR-SCX607-TI part code. The CNC machined 7075 aluminium piece replaces plastic arms to deliver improved stiffness between the servo output and steering linkages.

Check compatibility with Axial SCX6 Jeep JLU Wrangler 1/6 scale vehicles by confirming servo spline and mounting hole alignment before installation. The choice of 7075 aluminium provides enhanced strength for trail driving while keeping weight low.

To fit: remove the stock arm, align the new arm on the servo spline, and secure using the original retaining screw or an appropriate fastener. Verify full steering sweep and adjust tie-rod length or arm position if necessary to maintain proper toe and clearance. This is an aftermarket RC steering component and not for full-size use.

Can I use this arm on any servo with the same spline count?

If the spline count and overall spline diameter match your servo, the arm will typically fit, but always confirm hole spacing and clearances for your chassis.

What are the main benefits of upgrading to this arm?

Upgrading to a 7075 aluminium arm reduces flex under load, improves steering precision, and increases component longevity compared with plastic alternatives.

Do I need to change tie-rods when installing?

You may need slight tie-rod length adjustments or a different arm angle to restore correct steering geometry after installation; test and tweak as required.