AXIAL Wraith Offset Axle Link Mount AW-23017-GR Upgrade by Jazrider  [AW-23017-GR]

Axial Racing Wraith Aluminum Front Offset Axle Link Mount (Green)
Price:
USD$11.61
Brand:
JAZRIDER
Model:
AW-23017-GR
Condition:
Brand New
Write a review

Details for the AW-23017-GR front offset mount

The AW-23017-GR front offset axle link mount is made for AXIAL Wraith models. Constructed from machined aluminium and finished in green, the part repositions the front axle link attachment to influence steering and low-speed handling.

Installation is a direct replacement of the stock link mount: remove the factory part, fit the aluminium mount in the same position, and reuse the original hardware where appropriate while confirming link alignment and full suspension travel. Check for any binding during articulation.

Altering the front link attachment point changes front geometry and steering response, which can be used to dial in handling for rock or trail use. As with any metal hop-up, inspect mating surfaces regularly and apply correct torque and threadlocker practices to fasteners.

Can I reuse the stock mounting screws?

Often the original screws are suitable, but verify they are not worn and match thread size and length. Replace any damaged fasteners and use threadlocker where needed.

Will this part change steering geometry significantly?

The change is typically modest; the offset shifts the link pivot and can tighten low-speed steering response. Validate changes with test runs and fine-tune other settings if required.

What routine checks should I perform after fitting?

After installation, check fastener torque, inspect for play or binding, and re-check after the first run. Regular inspections will keep the mount performing reliably.