Axial Yeti Aftermarket Steering Linkage - YT-25005-BK by Jazrider  [YT-25005-BK]

Axial Racing Yeti Aluminum Steering Linkage (Black)
Price:
USD$6.27
Brand:
JAZRIDER
Model:
YT-25005-BK
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Aftermarket Steering Linkage for Axial Yeti

This aluminium steering linkage fits the Axial Yeti chassis and is identified as model YT-25005-BK. It replaces the stock plastic tie rods to give a more rigid connection between servo output and steering knuckles, reducing flex under load during technical driving.

Installation follows common Yeti procedures: remove the factory tie rods, swap or fit rod ends as required, and use the original hardware to secure the linkage. Apply a small amount of threadlocker to metal-to-metal threaded joints and verify neutral toe before final tightening. Re-check fasteners after a short break-in run to ensure components have seated properly.

The stiffer aluminum linkage provides a consistent reference point for setup and tuning, particularly when adjusting toe and Ackermann. Because it alters compliance, minor changes to servo endpoints or trim may be necessary. Inspect rod ends periodically and clean joints after dirty runs to maintain reliable steering performance.

Does this link improve steering precision?

Yes, the reduced flex of an aluminium linkage helps keep steering geometry consistent, which sharpens steering response on technical terrain.

Is installation reversible if I want to go back to plastic parts?

Installation uses standard hardware and rod ends, so you can revert to original components if desired; retain any transferred rod ends for compatibility.

What routine checks should I perform?

Periodically check rod-end play, verify fastener tightness, and clean joints after muddy or sandy conditions to prevent wear and keep steering predictable.