Axial Yeti XL Motor Mount Set YTL-25003 by Jazrider  [YTL-25003]

Axial Yeti XL Aluminum Motor Mount Set
Price:
USD$13.94
Brand:
JAZRIDER
Model:
YTL-25003
Condition:
Brand New
Write a review

Product Overview for YTL-25003

This aluminum motor mount set is an RC replacement part designed to secure and align the motor in Axial Yeti XL chassis configurations. It increases rigidity at the mounting area to help the motor keep position under load, supporting stable gear mesh and consistent drivetrain feedback during setup and tuning.

Installation follows common Yeti XL maintenance steps: remove the current motor mount, confirm motor shaft and pinion alignment, transfer motor and shims, then fix the new mount with the original screws. Check gear mesh and endplay before completing assembly and ensure there is no binding between the spur and pinion.

Tune guidance: because the mount dictates motor placement, small adjustments to spacing will alter mesh and noise characteristics. After installation, perform a slow power test to verify engagement, check for any chassis interference, and re-tighten fasteners after initial running.

Will this fit the Axial Yeti XL motor mounting pattern?

This part targets Yeti XL motor layouts; verify your chassis uses the standard Axial Yeti XL mounting points before purchase.

Do I need to buy additional parts to install it?

Installation typically reuses the motor, pinion, and original screws from the Yeti XL. No extra parts are listed with this mount, though you should retain original shims for correct mesh.