Axial Yeti XL Rear Lower Link Mounts Upgrade - YTL-25006 by Jazrider  [YTL-25006]

Axial Yeti XL Aluminum Rear Lower Chassis Suspension Link Mount Set
Price:
USD$8.13
Brand:
JAZRIDER
Model:
YTL-25006
Condition:
Brand New
Available in shop
Write a review

Aftermarket rear lower link mounts for Yeti XL

This aluminum rear lower chassis suspension link mount set is designed for the Axial Yeti XL chassis as a replacement for the stock lower link mounts. The parts stiffen the rear mounting points and provide a more rigid anchor for suspension links in scale off-road use.

Compatibility is defined for Axial Yeti XL models only. The product uses aluminum material, so installation involves replacing the factory plastic or OEM mounts using the original mounting locations and hardware on the Yeti XL chassis.

Installation: remove the stock rear lower link mounts from the Yeti XL rear rails, move over any required original pins or screws, and attach the aluminum mount pieces in the same positions. Use compatible hex drivers for the factory screw heads.

Tuning and service: reduced mount flex yields steadier rear link geometry during aggressive driving. Verify articulation and alignment after fitting, and perform periodic checks on fasteners for tightness.

Can I use these on other RC models?

They are intended for the Axial Yeti XL chassis only. Other models will likely have different mounting geometry so confirm measurements before attempting to fit them elsewhere.

Do these mounts require special tools?

No special tools are required beyond the standard hex drivers that match the factory screw heads used on the Yeti XL chassis.

What should I watch for after installing these?

After the first runs check fastener torque and verify that suspension articulation remains correct. Look for any signs of unexpected wear or interference and adjust as needed.