Element Enduro Trail Truck CNC Front Bumper Mount JR-EE09-S by Jazrider  [JR-EE09-S]

Element Enduro Aluminum Front Bumper Mount (Silver)
Price:
USD$9.60
Brand:
JAZRIDER
Model:
JR-EE09-S
Condition:
Brand New
Write a review

CNC aluminium front bumper mount for Element Enduro

This CNC-machined aluminium front bumper mount is a scale replacement crafted for the Element Enduro Trail Truck chassis. The part provides a stiffer mounting interface than stock plastic pieces, reducing flex and helping the bumper maintain its intended position on technical runs.

Installation is straightforward using the vehicle's existing bumper attachment points, and standard hex drivers are the only tools normally required. The mount is designed to accept original fasteners and typical bumper hardware without extra modification.

For trail setup this component increases durability at the front of the chassis and improves alignment consistency after impacts, which aids predictable behaviour on slow, technical sections while reducing repeated stress on plastic tabs.

How much weight does the aluminium mount add compared to the stock part?

The CNC aluminium piece is heavier than the original plastic mount but adds rigidity and durability; the trade-off is small compared with the benefit of reduced plastic fatigue.

Is the aluminium treated or finished to resist corrosion and wear?

Many machined aluminium parts receive a surface finish or anodising for wear resistance; check the seller listing for the specific finish applied to this unit.

Will this work with the stock Enduro bumper and hardware?

The mount is made for the Enduro chassis mounting pattern and is intended to accept the stock bumper and hardware in most cases; always verify fit and fastener compatibility during installation.