Front Knuckle Arms for TAMIYA TT-02B/DF-02, Direct-Fit Aluminium - JR-TT2B01-BK by Jazrider  [JR-TT2B01-BK]

Tamiya TT-02B / DF-02 Aluminum Front Knuckle Arms (Black)
Price:
USD$11.15
Brand:
JAZRIDER
Model:
JR-TT2B01-BK
Condition:
Brand New
Available in shop
Write a review

Direct-fit aluminium knuckles for TT-02B/DF-02 platforms

The JR-TT2B01-BK front knuckle arm set is an aluminium steering upgrade for TAMIYA TT-02B and DF-02 chassis configurations. The black-finished machined parts replace stock plastic knuckles to stiffen the steering pivot points and improve the consistency of wheel alignment under load.

Installation requires routine front-suspension disassembly: remove the factory knuckles, transfer hub pins, e-clips, bearings and shims as applicable, and fit the aluminium arms. Verify tie-rod geometry and ensure the steering linkage clears the new arms through full suspension travel. Typical hex drivers are all that are needed.

Aluminium knuckles reduce unwanted flex, delivering more immediate steering feedback and predictable geometry during tuning sessions. After initial running, inspect mounting interfaces and fasteners and re-torque hardware to confirm secure fitment.

Will these replace the standard knuckles without altering the hub?

Yes, they are intended to replace the stock knuckles on TT-02B and DF-02 front assemblies and should fit without hub modification.

Should I expect any additional maintenance with aluminium parts?

Routine checks are recommended; aluminium holds up well but inspect for impacts and check fastener torque after the first runs.

Does the upgrade change tuning strategy?

Because steering flex is reduced, small changes to toe and camber become more noticeable, so expect finer adjustments when dialling in handling.