Front Lower Arm Mount Upgrade for Tamiya Hornet EVO (Dark Blue) JR-THNE07-DB by Jazrider  [JR-THNE07-DB]

Price:
USD$7.00
Brand:
JAZRIDER
Model:
JR-THNE07-DB
Condition:
Brand New
Available in shop
Write a review

Aluminium front pickup mount for Hornet EVO

This aluminium front lower arm mount plate is a direct-fit replacement intended for the Tamiya Hornet EVO (58742). It provides a stiffer mounting surface than the stock plastic component to help maintain consistent 1/10 buggy suspension geometry.

Fitting requires basic RC maintenance skills; the plate uses the factory mounting layout and secures with standard hardware. Remove the original mount, fit this plate with common RC tools, and verify suspension travel and steering freedom prior to operation.

Designed to stabilise the front suspension pickup under load, the plate can aid predictable handling when you modify damping or spring rates. The dark blue finish is a visual aid during setup and maintenance.

Is the part compatible with the Hornet EVO only?

The plate is produced for the Hornet EVO (58742). Check the chassis and mounting hole pattern before trying to install it on other Hornet chassis.

Should I change torque settings when installing?

Use consistent torque on mounting screws to avoid distortion. Follow good practice for small RC hardware and re-check after a short run.

Any effect on overall handling to expect?

Expect reduced flex at the pickup point which can lead to a more consistent front-end response. Fine-tune setup parameters to match your driving preference.