Hotshot Rear Linkage Replacement Set for TAMIYA Hotshot - JR-THS09-GU by Jazrider  [JR-THS09-GU]

Tamiya Hotshot Rear Suspension Crank (Parts E2, E4, E6) With Ball Rod Set (Gun Metal)
Price:
USD$6.50
Brand:
JAZRIDER
Model:
JR-THS09-GU
Condition:
Brand New
Available in shop
Write a review

Hotshot rear linkage replacement set

This set provides replacement rear crank parts and a matching ball rod set for the Tamiya Hotshot, corresponding to the parts listed as E2, E4 and E6. The components are finished in gun metal and sold as spares for rear linkage repair and tuning work.

They are offered as direct-fit replacements to refresh worn linkage hardware or to rebuild the rear suspension assembly. Installation removes the original E2, E4 and E6 pieces and fits the supplied crank and ball rods, with a check on joint freedom and correct alignment before operation.

Use these parts to restore proper linkage geometry or replace aged hardware; they do not alter chassis design or electronics. Inspect nearby fasteners and bearings when reassembling and confirm that ball rod joints move freely.

Is this intended as a direct replacement for Hotshot rear parts?

Yes. The kit is specified to replace the E2, E4 and E6 rear linkage items on the Tamiya Hotshot.

What exactly is included in the replacement pack?

The pack includes the crank components that correspond to the factory E2, E4 and E6 pieces and a matched ball rod set, all in a gun metal finish for spare or repair use.

How should I verify correct fit after installation?

After fitting the new crank and rods, check each ball joint for free movement, confirm the linkage alignment matches the original geometry, and ensure hardware is secured to the recommended tightness before normal use.