HPI Baja Front Hub Carrier BAJA-60008-S Silver Alloy by Jazrider  [BAJA-60008-S]

HPI Baja - Silver Alloy front hub carrier
Price:
USD$28.80
Brand:
JAZRIDER
Model:
BAJA-60008-S
Condition:
Brand New
Write a review

Front Hub Carrier for HPI Baja Chassis

This front hub carrier is an RC-scale replacement part intended for HPI Baja models and is listed as BAJA-60008-S. It serves the front suspension assembly on off-road RC buggies as a direct-fit alloy alternative to typical stamped or moulded components.

Use it when repairing or upgrading front hubs; the silver alloy construction aims to provide improved stiffness compared with standard plastic parts, helping to maintain wheel alignment under load during off-road runs.

Specifications

  • Item: front hub carrier
  • Material: silver alloy
  • Model Number: BAJA-60008-S
  • Compatibility: HPI Baja

This silver alloy front hub carrier is a straightforward service part for hobbyists who need a durable replacement that preserves chassis geometry and supports consistent suspension behaviour.

What is the primary benefit of this alloy carrier?

The alloy carrier offers greater structural stiffness than common plastic alternatives, which helps reduce flex and maintain alignment when driving off-road.

Is installation straightforward for casual hobbyists?

Yes. The carrier is designed for direct fitment to the stock mounting points used on HPI Baja front hubs, so it installs using the same basic fasteners and procedures as the original part.

Does this change the need to inspect other components?

Upgrading to an alloy carrier makes it worthwhile to check adjacent parts such as bearings and drive components, since the stiffer mount can reveal underlying wear more readily.

What should I watch for after fitting?

After fitting, verify wheel alignment and fastener torque, then perform a short test run to confirm handling and that no unexpected binding or contact occurs.