HPI Bullet FLUX Aftermarket Steering Assembly - Orange Alloy BUL-18002-OR by Jazrider  [BUL-18002-OR]

HPI Bullet FLUX- Orange Alloy Steering Assembly Set w/Bearing
Price:
USD$12.77
Brand:
JAZRIDER
Model:
BUL-18002-OR
Condition:
Brand New
Available in shop
Write a review

Aftermarket Alloy Steering Assembly for Bullet FLUX

This orange alloy steering assembly is designed specifically for the HPI Bullet FLUX chassis as a replacement for plastic steering components. The unit incorporates bearings to reduce play and firm up steering linkage response. It functions as a chassis-level hop-up aimed at improving steering precision rather than changing drive power.

Installation overview

  • Remove the stock steering knuckles on Bullet FLUX MT or ST and install the alloy assembly into the same factory locations.
  • Where suitable, reuse factory fasteners but check bearing clearance against servo horns and tie-rods before final tightening.
  • Centre the steering after installation and verify toe and free travel to ensure consistent steering behavior.

Performance notes

  • Alloy knuckles with bearings reduce steering pivot slop, delivering more repeatable inputs for setup and testing.
  • Pair the upgrade with appropriate linkage geometry and servo configuration to balance steering responsiveness and stability.

Is this designed for MT and ST Bullet FLUX models?

Yes, the item is specified for Bullet FLUX MT and ST compatibility; always double-check chassis mounting points to confirm fitment before final installation.

Will I need special tools to fit the parts?

No special tools are required for standard replacement; a basic hex driver set and pliers will cover the typical installation steps.

How do I maintain the bearing pivots?

Keep bearings free of dirt, apply a light bearing lubricant compatible with your bearings, and inspect periodically for wear to keep steering performance consistent.