HPI Bullet Flux Centre Bulkhead Replacement BUL-18006-OR by Jazrider  [BUL-18006-OR]

HPI Bullet Flux - Orange Alloy Center Bulkhead Set
Price:
USD$16.26
Brand:
JAZRIDER
Model:
BUL-18006-OR
Condition:
Brand New
Available in shop
Write a review

Aftermarket Centre Bulkhead for Bullet Flux

This centre bulkhead is an aluminium aftermarket unit made for HPI Bullet Flux chassis, intended to provide a sturdier central mounting point for drivetrain and suspension linkages while matching original mounting geometry.

It fits Bullet Flux MT and ST variants as specified in product materials and functions as a direct replacement for compatible factory centre bulkheads. The alloy construction reduces central flex and offers a firmer platform for fine tuning chassis response.

To install, remove the OEM bulkhead, reuse appropriate hardware, and secure the alloy part to the original mounting points. Check alignment of drivetrain and suspension pivots and ensure fasteners are tightened to the recommended levels before use.

Perform regular inspections of fasteners and mating faces after use; aluminium components can extend service life but still benefit from scheduled maintenance following hard sessions.

Specifications

  • Item: HPI Bullet Flux - Orange Alloy Center Bulkhead Set
  • Material: Aluminium alloy
  • Model Number: BUL-18006-OR
  • Compatibility: HPI Bullet Flux

Opt for this orange-anodised centre bulkhead when you want a reliable, easy-to-identify upgrade that supports chassis tuning and consistent alignment on HPI Bullet Flux platforms.

What chassis are explicitly supported?

Support is declared for Bullet Flux MT and ST chassis families; check your vehicle against the compatibility list before purchase to confirm fit.

Does the anodised finish need any special care?

Normal cleaning and inspection are sufficient; avoid aggressive abrasives that could wear the finish, and inspect after impacts to ensure coating integrity.

Are there adjustments needed after fitting?

Typically only alignment checks and fastener torque verification are needed; minor setup tweaks may follow depending on the overall tuning goals.

Why choose aluminium over plastic for the centre bulkhead?

Aluminium offers improved rigidity and consistent mounting surfaces that help with tuning and reliability, though it may transmit more impact forces to connected components compared with some plastics.