HPI Bullet Front Chassis Brace BUL-18004-BK - Black Alloy by Jazrider  [BUL-18004-BK]

HPI Bullet - Black Alloy Front Chassis Brace
Price:
USD$10.45
Brand:
JAZRIDER
Model:
BUL-18004-BK
Condition:
Brand New
Write a review

Alloy front brace for HPI Bullet chassis

This black alloy front chassis brace is built as a replacement part for HPI Bullet models. It attaches to the front section of the Bullet 3.0 MT and ST (Nitro Engines) chassis to provide increased stiffness where the front bulkhead and main chassis meet.

The component is intended for structural reinforcement and tuning support rather than cosmetic change. The alloy construction offers a more stable mounting surface for front components and helps keep chassis alignment under stress during track or aggressive use.

Installation is typical for Bullet maintenance: remove the stock front brace or access the factory mounting points, align the alloy brace to the existing holes, and reuse OEM fasteners where compatible. Always check fit and clearances to steering linkages and the nitro engine before final torque.

Does this brace match the Bullet 3.0 MT/ST mounts?

The brace is intended for BULLET 3.0 MT and ST (Nitro Engines). Confirm that the mounting pattern on your chassis aligns with the brace before completing installation.

What improvements should I expect?

Expect increased front-end stiffness and a firmer platform for tuning, which helps maintain alignment during hard driving. Regular checks are recommended to monitor adjacent parts under the new load paths.

Any fitting advice to prevent issues?

Trial-fit the brace, cycle steering and throttle, and inspect clearances to servos and the nitro engine. Tighten fasteners progressively and recheck operation after a short test run.