HPI Bullet Front C Hub Carrier Black Alloy - BUL-18001-BK by Jazrider  [BUL-18001-BK]

HPI Bullet - Black Alloy Front C Hub Carrier
Price:
USD$10.22
Brand:
JAZRIDER
Model:
BUL-18001-BK
Condition:
Brand New
Write a review

Replacement C Hub Carrier Information

This front C hub carrier is provided as an aftermarket replacement suitable for HPI Bullet models listed as BULLET 3.0 MT and ST (Nitro Engines). It is described as a black alloy front C hub carrier that mounts the steering knuckle and connects the wheel hub to the vehicle's steering and suspension linkages.

When used in setup and tuning it establishes the hub mount points and affects alignment, bearing preload, and steering response. Fit using correct fasteners, check clearances prior to operation, and use common hand tools like a hex driver for removal and installation.

Which Bullet models are supported?

The carrier is intended for BULLET 3.0 MT and ST (Nitro Engines). Always verify chassis and mounting details before completing the purchase.

Will it accept standard bearings and hubs?

In most cases standard bearings and hubs will fit, but check bore sizes and spacing to ensure compatibility with your existing components.

What should I check after installation?

After installation check bearing preload, steering free play, and wheel alignment. Re-torque fasteners after a short test run to ensure secure mounting.