HPI Bullet Front C Hub Carrier Upgrade (Bullet 3.0) Orange Alloy - BUL-18001-OR by Jazrider  [BUL-18001-OR]

Product summary: Front C hub carrier for Bullet 3.0

An orange anodized alloy front C hub carrier designed as an aftermarket replacement for HPI Bullet platforms. It mounts between the steering knuckle and the front upright and is suitable for BULLET 3.0 MT and ST models, including nitro-powered configurations.

Finish and performance: the alloy construction and anodized finish resist wear from hinge pins and ball studs while providing a consistent surface for steering linkages. This firmer material reduces flex versus many stock plastic parts, helping steering inputs remain predictable.

Compatibility and fit: engineered to match the front suspension geometry used on Bullet 3.0 MT and ST. Where the original HPI mounting points are present, the carrier accepts existing hinge pins, ball studs and linkage geometry for a direct swap.

Installation pointers: remove the OEM C hub and transfer bearings, wheel hex and steering hardware as needed. After installation, verify toe, steering throw and ensure no binding through suspension movement. A stiffer carrier aids repeatable setup changes.

Note that packaging and included components vary by retailer; confirm what is supplied before you fit the part.