JAZRIDER BUL-18000-GU Gunmetal Knuckle Arms Practical Upgrade  [BUL-18000-GU]

HPI Bullet - Gunmetal Alloy Front Knuckle Arms
Price:
USD$10.68
Brand:
JAZRIDER
Model:
BUL-18000-GU
Condition:
Brand New
Write a review

Practical Knuckle Upgrade for HPI Bullet

The JAZRIDER BUL-18000-GU gunmetal alloy front knuckle arms are produced as a straightforward durability upgrade for HPI Bullet owners. They focus on long term serviceability and consistent steering feedback during everyday use.

Durability Focused Design

Made from gunmetal alloy, these knuckles reduce flex compared with standard plastic options and help keep wheel alignment stable under repeated nitro engine loads. That stability reduces frequent adjustments and downtime.

Fitment and Routine Service

These components are intended for HPI Bullet 3.0 MT and ST models and install with common RC workshop tools. Routine checks of fastener tightness and pivot cleanliness will keep the knuckles performing well.

How often should I inspect these knuckles?

Inspect after any heavy impact and as part of routine maintenance every few runs. Check for play at ball joints and ensure fasteners remain secure.

Do I need to replace any hardware when upgrading?

Use the vehicle's recommended hardware where possible. Replace any corroded or worn fasteners during the swap to ensure reliable clamping.

Are there tuning tips after fitting these knuckles?

With reduced flex you may want to recheck toe and steering end points. Small adjustments to steering geometry can help you achieve the desired feel.