HPI Bullet MT Universal Drive Shafts (Front/Rear) BUL-18012-BK Black Steel by Jazrider  [BUL-18012-BK]

HPI Bullet MT - Black Steel Front/Rear Universal Drive Shaft - 2pcs set
Price:
USD$13.94
Brand:
JAZRIDER
Model:
BUL-18012-BK
Condition:
Brand New
Write a review

Universal shaft replacement for Bullet MT vehicles

This RC-scale replacement drive shaft kit is designed for HPI Bullet MT models and is supplied as a 2-piece set with model number BUL-18012-BK. The items are finished in black steel to serve as front and rear universal shaft replacements on the Bullet MT chassis, intended for maintenance and off-road drivetrain strengthening.

To fit the shafts, remove the existing universal shafts, place the new shafts into the original coupling positions, and secure the retaining hardware while preserving alignment. Inspect hex adapters and hub mating surfaces before installation to ensure correct engagement and to prevent binding.

Upgrading to black steel drive shafts is a straightforward way to recover drivetrain performance lost to wear and to create a stable base for additional drivetrain enhancements. After installation, check for free rotation through the suspension travel and verify there is no excessive joint play.

How do I confirm these shafts match my Bullet MT?

Compare the attachment points and dimensions of your current shafts to the replacement set; ensure the coupling style and retaining hardware are compatible before proceeding with the swap.

What replacement interval should I use?

Inspect shafts periodically for wear, deformation, or joint looseness and replace them when any of these conditions appear to maintain drivetrain reliability.

Any post-install checks recommended?

After fitting, rotate the drivetrain through suspension movement, recheck hardware tightness, and perform a short low-speed run to listen for binding or unusual vibration before full operation.