HPI Bullet Rear Chassis Upgrade Brace, Gunmetal Alloy BUL-18008-GU for Bullet 3.0 MT/ST by Jazrider  [BUL-18008-GU]

HPI Bullet - Gunmetal Alloy Rear Chassis Brace
Price:
USD$11.61
Brand:
JAZRIDER
Model:
BUL-18008-GU
Condition:
Brand New
Write a review

Rear chassis brace for Bullet 3.0 MT/ST applications

This rear chassis brace is an RC-scale replacement part designed for HPI Bullet platforms and produced by JAZRIDER under model BUL-18008-GU. The gunmetal alloy rear brace is intended to increase rigidity in the rear section of the chassis for Bullet 3.0 MT and ST nitro variants.

The component is tuning-focused: by stiffening the rear it changes throttle transition behavior and rear traction on uneven terrain. It mounts to the standard rear attachment points and serves as a structural reinforcement rather than a powertrain modification.

Fitting advice: align with the rear bulkhead fasteners, check for any contact with exhaust or fuel tank plumbing on nitro setups, and use thread locker on metal fasteners if desired. After installation, re-evaluate chassis geometry and suspension to account for the stiffer rear response.

Can this brace be used on both MT and ST Bullet 3.0 models?

Yes. The brace is compatible with HPI Bullet 3.0 MT and Bullet 3.0 ST when installed at the rear chassis mounting points as intended.

What handling changes should I expect after fitting?

Expect a firmer rear with reduced flex; this can tighten throttle response and affect traction, so minor suspension or toe adjustments are commonly recommended to rebalance handling.

Is installation complex for someone experienced with chassis work?

No. Installation uses standard chassis fasteners and common hand tools. Verify alignment and clearances and use thread locker if preferred to secure metal fasteners.