HPI Savage X Cup Joint Replacement 8x14x19mm - HPI-86277 by Jazrider  [HPI-86277]

Price:
USD$0.00
Brand:
JAZRIDER
Model:
HPI-86277
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Replacement cup joint for Savage X drivetrains

The HPI-86277 cup joint set is intended as an RC-scale replacement for HPI Savage X drivetrains and is supplied in a silver finish as two components. Verify the 8x14x19mm sizing to ensure proper fitment and to avoid interference with your driveshaft assemblies.

Installation overview: replace one side at a time, inspect drivepins and surrounding parts for wear while the driveshaft is removed, seat the new joint correctly in the yoke, and reassemble using the original hardware with recommended torque. Common RC hand tools are sufficient for the task.

Maintenance summary: these cup joints should be checked periodically for play or scoring, kept free of debris, lightly lubricated on sliding interfaces as appropriate, and replaced in matched pairs when wear is evident to maintain driveline performance.

What must I check before purchasing this part?

Confirm the 8x14x19mm dimensions and the yoke interface on your Savage X to ensure the HPI-86277 will install without modification.

Is special maintenance required after fitting?

Routine checks for looseness and surface damage, occasional cleaning of contact areas, and light lubrication where needed will keep the joints performing well.

When should I schedule replacement?

Replace these components when you detect increased play, visible scoring, or reduced driveline precision to avoid further wear to adjacent parts.