JR-TASB01-BK Front Suspension Arms for Blitzer Beetle Fitment by Jazrider  [JR-TASB01-BK]

Aluminum Front Suspension Arms (Black) For Blitzer Beetle / Stadium Blitzer / Stadium Thunder
Price:
USD$13.90
Brand:
JAZRIDER
Model:
JR-TASB01-BK
Condition:
Brand New
Available in shop
Write a review

JR-TASB01-BK Aluminum Front Arms Overview

This RC aftermarket front arm set fits Blitzer Beetle, Stadium Blitzer and Stadium Thunder chassis. Finished in black anodized aluminum, the parts provide a stiffer option that improves wear resistance compared with original plastic components.

Intended use: the arms match the original front suspension mounting geometry so they are suitable for routine maintenance and as an upgrade to alter front flex and steering feedback during cornering.

Fitment advice: reuse the vehicle's existing hardware when appropriate, check ball stud and hinge pin fit carefully, and verify steering geometry and toe after fitting. Carry out staged testing and fine tune in small steps.

Tuning tips: adopting alloy arms usually requires modest shock and spring adjustments and roll center checks to balance the firmer front response without introducing instability.

Is the JR-TASB01-BK a direct replacement for the stock arms?

Yes, these arms are produced to fit the original mounting points for the listed models and typically install using the stock hardware; always check during assembly.

Will switching to alloy arms demand setup changes?

Expect reduced flex with alloy arms which often calls for small adjustments to damping and spring rates; proceed with incremental changes and evaluate handling carefully.

Are any clearance checks recommended after installation?

Yes, inspect alignment, hinge pin clearance and ball stud seating after fitting and before running the car to ensure reliable operation and avoid unexpected binding.