KYOSHO Fazer Mk2 FZ02 Aftermarket Wheel Shafts Front & Rear JR-KFZ202-LB by Jazrider  [JR-KFZ202-LB]

Kyosho Fazer Mk2 FZ02 Aluminum Front/Rear Wheel Shaft (Blue,2pcs)
Price:
USD$5.40
Brand:
JAZRIDER
Model:
JR-KFZ202-LB
Condition:
Brand New
Available in shop
Write a review

Aftermarket shaft details for the Fazer Mk2

This set contains front and rear wheel shafts intended for the KYOSHO Fazer Mk2 FZ02 chassis, supplied as two blue anodized aluminum shafts. They offer a metal replacement option where the factory pieces are plastic or lower-grade metal and are intended to improve wheel seating consistency.

Install these shafts when wheel retention and lateral play are factors in handling performance. Confirm your vehicle uses the FZ02 wheel shaft configuration before fitting to ensure compatibility with the referenced design.

Fitting is suitable for a hobby workshop: remove wheel and hub, swap the original shaft for the replacement, then reassemble and check wheel runout and bearing alignment. Use appropriate hex tools, avoid over-torquing, and recheck fasteners after initial runs to confirm secure seating.

Is this an OEM part?

This is an aftermarket upgrade intended to match the FZ02 wheel shaft pattern; it is not produced by the original chassis manufacturer but is made to fit the KYOSHO FZ02 layout.

How do I confirm the new shafts run true?

After installation, spin the wheel and observe for wobble; check bearing seating and ensure hubs are torqued evenly. Small adjustments or bearing replacement may be required to achieve optimal runout.

Any special maintenance tips?

Keep the shafts clean after use in wet or dirty conditions, inspect for surface damage, and verify bearing condition regularly to maintain consistent wheel alignment and performance.