KYOSHO Fazer Mk2 FZ02 Center Shaft Cup Joint Upgrade, Anodized Aluminum JR-KFZ201-LB by Jazrider  [JR-KFZ201-LB]

Kyosho Fazer Mk2 FZ02 Aluminum Center Shaft Cup Joint (Blue)
Price:
USD$6.40
Brand:
JAZRIDER
Model:
JR-KFZ201-LB
Condition:
Brand New
Available in shop
Write a review

Precision center cup for Fazer Mk2 drivelines

This anodized blue aluminum center shaft cup joint is supplied as a direct replacement hop-up for the Kyosho Fazer Mk2 FZ02 driveline. It creates a firmer interface at the point where the driveshaft engages the center shaft, intended to reduce play and improve overall driveline predictability.

Machined from anodized aluminum, the component emphasizes consistent geometry and improved wear resistance so that alignment and straightness are easier to maintain. Use it when inspecting the driveline, replacing aged parts, or upgrading to metal hardware for more predictable behavior during high use.

Install by removing the center driveshaft assembly, inspecting mating faces and bearings, transferring or renewing retaining hardware as needed, and fitting the new cup while ensuring correct alignment and free rotation prior to final assembly. After fitting, confirm the driveline runs true with no binding.

Compatibility

  • Kyosho Fazer Mk2 FZ02

Is this intended as a direct swap for the stock cup?

Yes. It is engineered to replace the original plastic cup in the Kyosho Fazer Mk2 FZ02 center driveline with minimal modification when installed correctly.

Could the anodized finish affect mechanical contact?

The anodized layer is mainly protective and cosmetic; properly machined tolerances ensure that the finish does not interfere with mechanical fit when the part is installed as directed.

Any post-install checks recommended?

After installation, rotate the driveline by hand to check for smooth operation and absence of binding, then recheck hardware after an initial run to ensure secure fitment.