Kyosho Optima 2016 Front Knuckle Upgrade JR-OT01 by Jazrider  [JR-OT01]

Kyosho Optima 2016 Aluminum Front Knuckle
Price:
USD$9.99
Brand:
JAZRIDER
Model:
JR-OT01
Condition:
Brand New
Available in shop
Write a review

Optima 2016 CNC front knuckle

This front knuckle is a CNC aluminium replacement for the Kyosho Optima 2016 chassis, intended to replace the standard plastic part with a stiffer steering mounting solution and more consistent geometry under load. The content concentrates on fit, installation guidance, and the tuning role of the component rather than making direct performance claims.

Installation notes: the knuckle secures to the original steering upright and suspension tower anchor points on the Optima 2016 and matches the factory bore positions. Verify steering linkage clearances and thread compatibility for hex screws and ball studs before final assembly. Remove the stock component carefully, position the new knuckle on the upright, and fasten using the original mounting hardware or equivalent fasteners matching the thread and length.

Tuning role: replacing the plastic knuckle with aluminium reduces local compliance at the steering pivot, changing steering feedback and response to bumps. Use this part when adjusting toe, camber link settings, or shock valving to fine tune steering characteristics without modifying the base chassis geometry.

Is this a direct swap for the Optima 2016 upright?

Yes, it is made for the Optima 2016 layout and aligns with the original mounting points, though you should confirm fit on your upright before final fitting.

Will I need to replace bearings or studs?

In most cases the original bearings and studs will fit. Inspect for wear and confirm sizes; replace any worn components during installation for best results.

What tuning changes are commonly needed after fitting?

Expect reduced pivot flex and altered steering feedback; recommended adjustments include toe and shock valving changes, plus checking camber link positions to achieve the desired steering balance.