JAZRIDER JR-HAG-TX450-019T Metal Tail Holder Set for Align T-Rex 450 SE V2  [JR-HAG-TX450-019T]

Metal Tail Holder Set For Align Trex T-rex 450 AE SE V2 Alloy parts - Jazrider Brand [JR-HAG-TX450-019T]
Price:
USD$16.14
Brand:
JAZRIDER
Model:
JR-HAG-TX450-019T
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Durable Tail Mounting Solution for T-Rex 450 SE V2

The JAZRIDER JR-HAG-TX450-019T metal tail holder is a practical upgrade for Align T-Rex 450 SE V2 owners seeking a long lasting mount that reduces mechanical play and simplifies setup. The component is machined to provide consistent fit and function in routine use.

Practical Gains in Rigidity and Serviceability

Switching from plastic to metal improves resistance to wear and limits flex at the tail pivot. This reduces the need for frequent trimming and makes routine maintenance and checks easier for the hobbyist.

Direct Replacement for Align T-Rex 450 SE V2 Geometry

The part matches the Align T-Rex 450 SE V2 mounting interface, enabling straightforward installation without complicated modification. The design supports typical tail servo and linkage arrangements used by most pilots.

What should I check after fitting the metal holder?

Confirm fastener torque, check tail boom alignment and verify free play in linkages. Recheck after a few flights to ensure nothing has bedded in loose.

Is any break in required for this part?

No special break in is necessary. Fit correctly, inspect for interference, then perform a control check before normal flying. Monitor for wear over time.

Will this part change required gyro tuning?

A stiffer tail mount can alter the feel of the tail response slightly. You may need small gyro gain adjustments to optimise behaviour after installation.