Jazrider JR-HAG-TX450-020 Metal Tail Rotor Grip Set Technical Edition  [JR-HAG-TX450-020]

Metal Tail Rotor Grip Set For Align Trex T-rex 450 AE SE V2 Alloy parts - Jazrider Brand [JR-HAG-TX450-020]
Price:
USD$13.99
Brand:
JAZRIDER
Model:
JR-HAG-TX450-020
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Jazrider Alloy Tail Rotor Grip Set for Align T-Rex 450 SE V2

The Jazrider Metal Tail Rotor Grip Set is a practical, durable replacement for the Align T-Rex 450 SE V2 tail assembly. Manufactured to maintain correct linkage geometry, the alloy grips reduce slop and simplify setup for regular flying.

Robust Alloy Components for Everyday Use

Fabricated from quality metal, these grips resist the common wear modes seen in plastic parts. Their dimensional stability supports consistent control inputs and reduces the need for frequent part swaps.

Fit and Function for Reliable Tail Response

Parts are profiled to align with the T-Rex 450 SE V2 mounting points and link positions, enabling predictable motion and cleaner transmission of servo commands to the tail rotor.

Maintenance and Installation Notes

When installing, check shaft clearances and fastener torque. Use light lubrication on moving pivots and verify tail gyro settings after the upgrade to account for any change in mass or friction.

What torque and threadlocker recommendations apply?

Use manufacturer recommended torque for small machine screws and a medium strength threadlocker where metal-to-metal fastening is present to prevent loosening without risking seizure.

Should I adjust tail gyro after fitting these parts?

Yes. After installing alloy grips, perform a hover and small-amplitude tests to refine gyro gain and eliminate any tendencies to under or over damp the tail.

Are replacement pivot pins or bearings needed?

Inspect existing pins and bearings; replace any items showing wear. Using fresh, correctly sized bearings and hardened pins preserves the benefit of the alloy grips.