Optima 2016 Rear Hub Carrier Aluminum - JR-OT13 by Jazrider  [JR-OT13]

Kyosho Optima 2016 Aluminum Rear Hubs Carrier
Price:
USD$10.45
Brand:
JAZRIDER
Model:
JR-OT13
Condition:
Brand New
Available in shop
Write a review
alt="Kyosho Optima 2016 Aluminum Rear Hubs Carrier" title="Kyosho Optima 2016 Aluminum Rear Hubs Carrier"

JR-OT13 Rear Hub Carrier for Optima 2016

This alloy rear hub carrier is produced for the Kyosho Optima 2016 chassis and is identified by model JR-OT13. It replaces the original carrier to create a stiffer mount for the rear suspension and wheel hub while keeping the correct Optima 2016 geometry.

Installation uses the same mounting points as the stock part on 1/10 4WD buggies. Clean axle ends, wheel hexes and hub faces, then refit screws with proper thread engagement. Standard RC hex drivers and hand tools are sufficient for the job.

As an upgrade, an aluminium carrier reduces rear hub flex to give more consistent suspension action under cornering and acceleration. When tuning anti-squat or rear roll, check that the carrier aligns with chosen shock positions and toe inserts to retain predictable handling behavior.

Will JR-OT13 fit the standard Optima 2016 without modifications?

Yes, JR-OT13 is designed as a direct replacement for the stock Optima 2016 rear carrier; check that your vehicle uses the standard Optima 2016 rear hub components for a plug-and-play fit.

Any special setup tips after fitting this aluminium carrier?

After fitting, verify suspension geometry and wheel alignment, and perform a test run to confirm handling. Minor shock or toe tweaks may be needed to balance the stiffer rear mounting.