Red Aluminum Front Suspension Arms for Blitzer Platforms - JR-TASB01-RD by Jazrider  [JR-TASB01-RD]

Aluminum Front Suspension Arms (Red) For Blitzer Beetle / Stadium Blitzer / Stadium Thunder
Price:
USD$13.90
Brand:
JAZRIDER
Model:
JR-TASB01-RD
Condition:
Brand New
Available in shop
Write a review

Machined Red Front Arms for Blitzer Range

These precision machined aluminum front suspension arms are offered as an aftermarket accessory for the Blitzer Beetle, Stadium Blitzer and Stadium Thunder RC vehicles. They concentrate on strengthening the front suspension mount and the mechanical link to hub carriers.

Aluminum arms provide a firmer attachment than typical plastic parts, impacting steering feedback and the evolution of camber and toe during suspension travel. Check hinge pin fit and retainer clearances during installation and confirm the same fitment on both sides to maintain predictable steering.

Setup guidance: expect changes in front-end compliance that may call for small adjustments to ride height, spring rate or toe to rebalance handling. Verify suspension geometry after initial runs to finalise settings.

Compatibility

  • Blitzer Beetle
  • Stadium Blitzer
  • Stadium Thunder

Is this a direct-fit replacement for the stock arms?

The arms are intended for the listed Blitzer models; however, confirm your chassis hinge pin diameter and mount spacing before installation to ensure compatibility.

Should I change other suspension parts when fitting these arms?

Consider checking shocks, springs and toe settings after fitting, as the reduced flex can alter handling and may require minor adjustments to restore balance.