JAZRIDER JR-RG803-RD Front Aluminium C-Hub Caster Mounts for Redcat Gen8  [JR-RG803-RD]

Redcat Gen8 Aluminum Front C-Hub Caster Mounts (Red)
Price:
USD$12.08
Brand:
JAZRIDER
Model:
JR-RG803-RD
Condition:
Brand New
Available in warehouse
Write a review

Practical aluminium C-hub mounts for everyday Redcat Gen8 use

The JAZRIDER JR-RG803-RD Aluminium Front C-Hub Caster Mounts are a straightforward upgrade that increases front end durability on the Redcat Gen8. Built from aluminium to resist impact and repeated stress, these mounts aim to improve steering feel and reliability without complex installation.

Why choose an aluminium upgrade

Aluminium delivers a solid balance of strength and weight for routine off-road usage. The material helps reduce mounting deformation and can lower the rate of front end failures during regular running.

Simple fitment and user friendly service

These mounts are produced to align with Gen8 front geometry for a direct replacement. Installation is compatible with typical RC hand tools, and routine checks such as torque verification keep the upgrade performing well.

Everyday benefits for hobbyists

Swapping in aluminium C-hub mounts results in steadier steering inputs, reduced steering play and lower wear on adjacent components. That makes day to day running more predictable and reduces the need for frequent part replacements.

Will these install using standard Gen8 hardware?

Yes, they are designed for the Gen8 mounting points and use common front end fasteners. Check supplied hardware and replace any worn bolts during the swap.

Are there any special break in or run in steps?

No special break in is required. After fitting, confirm bolt torque and run a short test session to verify alignment before full use.

Does the upgrade need other matching parts?

These mounts are compatible with standard Gen8 front suspension components. Inspect bearings, hubs and linkages for wear and refresh them if necessary to get the best longevity from the aluminium mounts.