Jazrider JAZRIDER JR-CBR-TM-031 Metal Shielded Ball Bearing Set for Tamiya 56323 Scania R620  [JR-CBR-TM-031]

TAMIYA 56323 R620 Scania Metal Shielded RC Ball Bearing Set - Jazrider [JR-CBR-TM-031]
Price:
USD$11.26
Brand:
JAZRIDER
Model:
JR-CBR-TM-031
Condition:
Brand New
Available in warehouse
2 Reviews
Write a review

Practical Bearing Upgrade for Tamiya 56323 Using Jazrider Components

The Jazrider JAZRIDER JR-CBR-TM-031 is a 32 piece metal shielded ball bearing kit intended to replace factory bearings in the Tamiya 56323 Scania R620. These shielded units reduce contact friction and provide consistent rolling under ordinary hobby use.

Kit Composition

Kit contents are sized for common mounting positions on the truck chassis and hubs:

  • 5 x 11 x 4mm (27 pieces)
  • 6 x 12 x 4mm (4 pieces)
  • 5 x 8 x 2.5mm (1 piece)

The metal shields help reduce ingress of larger debris while maintaining acceptable rotational freedom for everyday running.

Installation and Routine Care

Prepare bearing seats by cleaning and inspecting for wear. When installing, support the outer race to avoid inner race damage. Perform light maintenance checks and apply minimal oil to maintain low friction without attracting dust.

 

Product Reviews
2 Reviews
rating
Great arrived early ready to fit into model
rating
Great service and always on time! It would be great if you can list the things that could fit into my package in terms of weight. I will add more into my cart. Thanks for the great service! I really appreciate it.

Is this kit a direct replacement for the stock bearings?

These bearings are supplied to match the common bearing locations on the Tamiya 56323 but verify dimensions against the parts you are replacing before installation.

How should I maintain these shielded bearings?

Inspect annually or after heavy use, remove grit from the mounting area and apply a light penetrating oil if rotation feels stiff. Avoid heavy greases that trap dirt.

Are special tools required to fit them?

A bearing press or a socket that contacts only the outer race is recommended to avoid damage. Hand press or tapping should be done carefully to protect the bearing internals.