TAMIYA CC-02 Aftermarket Aluminum Upper Link Mount - JR-CC204-S by Jazrider  [JR-CC204-S]

Tamiya CC-02 Chassis Aluminum Upper Suspension Link Mount (Silver)
Price:
USD$5.81
Brand:
JAZRIDER
Model:
JR-CC204-S
Condition:
Brand New
Available in shop
Write a review

Aftermarket upper suspension link mount for CC-02

This aluminium upper suspension link mount is supplied as an RC-scale replacement specifically for the TAMIYA CC-02 chassis. It replaces the factory plastic mount and establishes a more secure pivot for the upper suspension link.

The component promotes stable upper link positioning under load, which assists in maintaining predictable suspension geometry when adjusting droop, camber or roll centre. The neutral configuration focuses on accurate placement and repeatability rather than modifying suspension travel or damping.

Installation follows the CC-02 stock mounting points. Remove the original part per the chassis instructions, transfer any required hardware and link ends, and secure this aluminium mount with the existing fasteners. Refer to the CC-02 manual for torque and assembly order to avoid over-tightening.

What should I expect after upgrading to this mount?

You should notice reduced movement at the upper link pivot, which yields more repeatable suspension behaviour and makes tuning camber and droop settings more consistent session to session.

Does this part extend service life compared to plastic?

Aluminium resists deformation and wear better than the stock plastic mount, so it typically lasts longer under similar use conditions; regular inspection of mounting hardware is still advised.

Will fitting this change suspension travel?

No, the mount keeps original geometry and mounting positions. Its role is to stabilise the pivot rather than alter travel or damping characteristics.