Tamiya CC-02 Front/Rear Shock Tower (Aluminium Upgrade) JR-CC203-RD by Jazrider  [JR-CC203-RD]

Tamiya CC-02 Chassis Aluminum Front/Rear Shock Tower (Red)
Price:
USD$10.70
Brand:
JAZRIDER
Model:
JR-CC203-RD
Condition:
Brand New
Available in shop
Write a review

Aluminum shock tower upgrade for CC-02

This front and rear shock tower assembly is an aluminium replacement suitable for Tamiya CC-02 chassis setups. Machined and red anodised, the components swap in for original plastic towers to provide a sturdier top mount for shocks and to reduce flex in the suspension attachment area when using more robust aftermarket shock units.

Install these towers to gain consistent mounting points for setup work or when fitting shocks that require precise eyelet placement. The parts govern shock top positioning, influence leverage and roll behavior, and provide repeatable anchors for suspension tuning tasks.

Fitment recommendations: retain original fasteners where feasible, verify alignment before final tightening, and recheck shock length and preload after fitment to restore intended ride height and suspension travel. Supplied as an accessory; additional hardware is not included unless specified by the seller.

Does this replace the standard CC-02 towers?

Yes, these alloy towers are intended to take the place of the factory plastic towers on standard CC-02 chassis that retain the original shock mount positions.

Are the mounts compatible with standard shock eyelets?

They are machined to accept standard eyelet dimensions used on CC-02 style shocks, but always double-check eyelet spacing and clearance before tightening to avoid binding.

Will this change required maintenance intervals?

Aluminium is more durable than plastic and reduces deformation, but inspect mounting hardware and anodised surfaces periodically and tighten fasteners as part of routine maintenance.