Tamiya Compatible Aluminum Rear Hub for Thunder Shot/Thunder Dragon/Fire Dragon/Terra Scorcher - JR-TFD03-LB by Jazrider  [JR-TFD03-LB]

Tamiya Thunder shot/ Thunder Dragon/ Fire Dragon/ Terra Scorcher Aluminum Rear Hub (Blue)
Price:
USD$11.20
Brand:
JAZRIDER
Model:
JR-TFD03-LB
Condition:
Brand New
Available in shop
1 Reviews
Write a review

Product overview: aluminum rear hub

This JR-TFD03-LB aluminum rear hub from JAZRIDER is an aftermarket RC replacement for Tamiya Thunder Shot, Thunder Dragon, Fire Dragon, and Terra Scorcher buggies. The blue anodized finish and direct-fit design make it a replacement option where the original hub mounting interfaces match.

Metal construction reduces flex at the wheel mount compared with stock plastic hubs, helping maintain alignment under load and supporting setup changes that affect traction and steering. Intended for model and track use only.

Installation and tuning notes

  • Confirm fitment: verify the hub matches the existing wheel hex and axle interface before installation.
  • Use the original fasteners where possible to retain correct thread engagement and stack height.
  • Check 走珠軸承 seating and axle clearance after installation to ensure free rotation without binding.
  • When adjusting toe or camber, recheck wheel runout and hub tightness as metal parts change stiffness compared with plastic counterparts.
  • Routine inspection is recommended after initial runs to confirm no loosening of mounting hardware.

 

Product Reviews
1 Reviews
rating
Great stuff. Love the upgrades. Wish they did more though, love jazzing up my cars

What is JR-TFD03-LB designed to replace?

JR-TFD03-LB is an aluminum rear hub intended to replace compatible plastic rear hubs on the specified Tamiya models when the mounting interfaces match the original parts.

Is special tooling required to install the hub?

Installation typically uses standard RC hand tools; ensure you have appropriate hex drivers and torque control to avoid over-tightening or damaging threads.

How should I care for the hub after fitment?

Inspect mounting hardware and finish after initial runs, check for any binding at the axle, and verify that wheel runout remains within acceptable limits for your setup.