TAMIYA Compatible Rear Upper Suspension Arms (Aluminum, Red) JR-THS05-RD by Jazrider  [JR-THS05-RD]

Tamiya Hotshot, Super Hotshot Aluminum Rear Upper Suspension Arms (Red)
Price:
USD$15.10
Brand:
JAZRIDER
Model:
JR-THS05-RD
Condition:
Brand New
Available in shop
Write a review

Aftermarket Aluminum Rear Upper Arms for Hotshot

This machined aluminium rear upper arm kit is intended as an aftermarket hop-up for Tamiya Hotshot and Super Hotshot chassis. Components are red-finished and produced to align with stock mounting points so they serve as direct replacements where geometry matches the original design.

Swapping to these aluminium arms reduces link flex versus plastic, promoting consistent suspension geometry while tuning. Installation generally mirrors the factory arm replacement steps and may permit reuse of original pins and fasteners when compatible; always confirm smooth suspension travel and clearances after fitting.

Specifications

  • Item: Rear upper suspension arms
  • Material: Aluminum
  • Model Number: JR-THS05-RD
  • Compatibility: Tamiya Hotshot, Super Hotshot

A reliable aluminium swap for enthusiasts targeting repeatable suspension behavior and improved setup control on classic Hotshot platforms.

This product is an aftermarket hop-up designed to replace stock rear upper arms on compatible Hotshot-series chassis; it is not produced by the original vehicle manufacturer.
Aluminium arms reduce flex under load, which can improve consistency in suspension geometry and deliver a more predictable handling platform during tuning sessions.
Follow the original arm removal procedure, keep fasteners clean, and test-fit before final torqueing. Recheck clearances after an initial short run to ensure no interference.
Inspect regularly for damage, tighten mounting hardware as needed, and clean grit from pivot areas to prevent premature wear. Replace any arm showing deformation or cracking.